All new
or existing floor surfaces to be coated are mechanically prepped
and cleaned to assure a successful installation. New concrete
floors must be at least 28 days old. All oil, grease, wax, curing
compounds, water-soluble hardeners, loose/chipping paint or
other surface contaminants are removed.
Patch is then used to fill cracks, spalled areas and expansion
joints. The floor surface is then coated and finished with the
desired floor system. Concrete Finishes can create a floor design
to compliment your environment. Custom patterns and colours,
graphic inlays or overlays can be added for a distinct touch.
Trowel
Overlay
There are times when concrete is so deteriorated that costly
maintenance, extensive repair are no longer effective. A trowel
overlay system can make old, damaged or weak concrete as good
as new. Whether the floors poor performance was caused by
water damage, surface stress, improper curing, spalling or
joint failure, this program provides all the steps necessary
to restore and rejuvenate the integrity and appearance of
the floor.
A high performance, three component, aggregate seamless system
for extremely demanding environments. The overlay method is
designed for use on new/existing floors or for resurfacing
deteriorated, severely worn concrete floors.
Formulated by blending 100% solids epoxy liquids with specially
graded quartz silica aggregates, this system consists of a
primer, a three component mortar trowel applied up to 1/4"
(6mm) thick, a two component solid grout coat and sealed with
a two component solid topcoat.
For an incredible resistance to harsh environments subject
to relentless, industrial-like traffic, impact, abrasion,
chemicals and liquid immersion, Concrete Finishes' trowel
overlay should be your system of choice.
|